Installing an Eicon Diva Server ISDN Adapter

The Eicon Diva Server Adapter should be installed into the server as per the installation instructions provided with the card. The list of currently supported EICON cards is available from HTU http://kbase.gfi.com/showarticle.asp?id=KBID001220UTH. The latest drivers, Installation guides and support for the Eicon product range is available from the Eicon website at HTUhttp://www.eicon.com.

I Current Eicon adapters are Universal PCI (3.3/5 volts), however always check the technical details of the adapter to make sure the adapter is suitable for the server hardware.

GFI FAXmaker uses CAPI (Common ISDN Application Programming Interface - www.capi.org) to interface with supported EICON (&AVM) ISDN cards. CAPI support is provided by installing the Eicon Diva Server software and drivers.

Screenshot 5 - Diva Server Configuration Wizard: - Configuring CAPI to answer all calls.

Installing the Eicon Diva Server software on the server will launch the Diva Server Configuration Wizard. First choose the ISDN switch type that is used by your country and then configure CAPI to `Accept all incoming calls'.

Screenshot 6 - Diva Server Line Check: Test the ISDN service using this utility from the start menu.

After running the Eicon Diva Server Configuration wizard you should restart the server. Then run a line check using the Diva Server Line Check utility included with the Diva Server software. If the line check passes you can continue with installation of FAXmaker. An unsuccessful line check will return an error code which can be referenced on the Eicon technical support website for the cause and a list of possible solutions.

I You can use the Eicon Diva Server Configuration Manager utility to setup advanced configurations such as sharing the Eicon Adapter between FAXmaker and Routing and Remote Access for dial-up access. For further information on this consult the Eicon documentation.