Fax line options - Advanced
This tab allows you to configure advanced fax line options
The advanced line/device options
Auto print
Auto print allows you to automatically print faxes received on this line. This way, you can select different printers to print out faxes received on different fax lines.
To select the printer(s) click on Set-up. If you want your faxes to be auto-fitted, select Nearest Size. If you are sure you are only going to receive one fax format, you can select that format: A4 only, Letter only or Legal only.
If you have chosen Nearest Size, you must set up a printer (this can be the same printer) for each page format. If you have chosen one format only, you must set up a printer for that format.
Auto print set-up
* Printing of outgoing faxes is configured in the Sending options node.
Archiving
Archiving allows you to create a backup of all incoming and outgoing faxes.
Archive incoming: Archives all incoming faxes in a directory of your choice.
Archive outgoing: Archives all outgoing faxes in a directory of your choice.
If you have the OCR module installed, FAXmaker will store the OCR text output in the same directory, using the same file name as the corresponding fax file, but using extension *.txt instead of *.fax.
DTMF/DID routing options
Here you set-up routing options specific to this fax line. Note that the main routing configuration is done from the routing node.
Note: Some of these options will appear greyed out depending on what device you are using. Note that standard fax modems have no routing capabilities.
Number of DTMF/DID digits to capture: Length of DTMF string/number that caller or PBX must generate. For example, if you are going to use from 1-9 only, enter 1; up to 99, use 2 digits; up to 999, use 3; and so on. Be aware that if you enter a certain amount of digits, the sender must enter all the digits for the fax to be routed correctly. For example, if the digits are set to 3, and the DTMF number is 6, the sender must enter 006 not just 6. Another option would be to enter 6# (the # implies number complete).
Generate beep before capture: specifies that the modem should give a beep when it answers the call as a signal to the user to enter the DTMF number. It is recommended that this option is always selected. The tone of the beep may be selected from the drop down box. The tone can be a DTMF tone or a frequency from the selected range.
Flash after DTMF capture and before tone: This option is used only for Multitech modems. When this option is enabled, after successfully detecting tone, the fax server goes 500ms on hook (flash) and then start receiving the fax.
