Phone Lines icon GFI Support

Articles in this section

See more

Exinda CLI : Bridge

Author: Sughra Mehdi Updated

Overview

 

You can use the bridge command to enable or disable bridges within the application. The interfaces available for a bridge are determined by the appliance model and installed expansion cards. Once enabled, an interface is created for the bridge which can be used in other commands.

This article provides information regarding the CLI command bridge.

 

Information

 

NOTE:  The following syntax convention is used:
  • {}: Options are enclosed in braces and are separated by '|'
  • []: Optional keywords are enclosed in brackets
  • <>: User input is required where variables are enclosed in greater-than and less-than symbols

The following table describes the commands used for performing common actions related to bridges:

 

Action Description Command Parameter Description

To enable or disable the specified bridge

 [no] bridge <bridge> enable NA (Not Applicable) 

To specify the ageing time for this bridge

 bridge <bridge> ageing-time <ageing-time> NA (Not Applicable)  

To specify the forwarding time for this bridge

 bridge <bridge> forward-time <forward time> NA (Not Applicable)  

To specify the hello time for this bridge

 bridge <bridge> hello-time <hello time> NA (Not Applicable)  

To specify the max-age for this bridge

 bridge <bridge> max-age <max age> NA (Not Applicable)  

To specify the priority for this bridge

 bridge <bridge> priority <priority> NA (Not Applicable)  

To enable or disable the Spanning Tree Protocol for this bridge

 [no] bridge <bridge> spanning-tree enable NA (Not Applicable)  

To specify the bandwidth at which the bridge auto-license mode switches from single-queue to multi-queue

 bridge <bridge-name> mq switch-bandwidth <bandwidth> NA (Not Applicable)  

To set the bridge interface to provide QoS based on queue mode

bridge <bridge-name> mq mode [auto-license|multi|single]

  • mq mode auto-license — Single or multi-queue is automatically selected based on the license.
  • mq mode multi — QoS uses a multi-queue network interface configuration.
  • mq mode single — QoS uses a single-queue network interface configuration.

To view the current bridge configuration

 show bridges NA (Not Applicable)  

 

Related Article

Find more CLI commands.

Back to Top