Overview
This article provides information regarding the Exinda CLI command stats.
You can use the stats command to configure alarms. Alarms are used to notify the administrator when certain thresholds are reached.
Information
- {}: Options are enclosed in braces and are separated by '|'.
- []: Optional keywords are enclosed in brackets.
- <>: User input is required where variables are enclosed in greater-than and less-than symbols
The following list describes the commands used for performing common actions related to alarms:
- To configure alarms based on sampled or computed statistics:
stats alarm {asymmetric_route|auto_neg|bridge_direction|bridge_link|cifs_signed|concurrent_accel|cpu_util_indiv|diag|disk_io|exinda_connlimit|exinda_cpu_indiv|exinda_paging|fs_mnt|if_collisions|intf_util|mapi_encrypted|memory_pct_used|pagign|redundant_power|redundant_storage|rx_dropped|rx_errors|startup|tx_errors} - To configure computed historical data points
stats chd - To clear data for all samples and CHDs, and status for all alarms
stats clear-all - To configure sampled statistics
stats sample - To export statistics to a file
stats export csv {cpu_util|exinda_cpu|memory|paging} {after|before|filename}cpu_util - Export the CPU utilization of the appliance
exinda_cpu - Export the CPU utilization of the appliance
memory - Export the memory utilization of the appliance
paging - Export the paging data of the appliance
after <yyyy>/<mm>/<dd> - Export only statistics collected after the specified date
before <yyyy>/<mm>/<dd> - Export only statistics collected before the specified date
filename <filename> - Specify the filename for the exported data
Example
-
Enable the calculations of 5-minute web reduction (measures the amount of redundant data that has been removed from the network, increasing capacity) samples
stats chd web_reduction_fiveminutes enable
-
Enable the interface errors alarm
stats alarm if_collisions enable
-
Configure the QoS sample interval to 120 seconds
stats sample qos interval 120
Find more CLI commands.