Phone Lines icon GFI Support

Articles in this section

See more

Exinda CLI: Network User

Author: Sughra Mehdi Updated

Overview

 

This article provides information regarding the Exinda CLI command network-user.

You can use the network-user command to manually create network objects based on an IP address or to dynamically create a network object based on an Active Directory group or user.

 

Information

 

NOTE:  The following syntax convention is used:
  • {}: Options are enclosed in braces and are separated by '|'
  • []: Optional keywords are enclosed in brackets
  • <>: User input is required where variables are enclosed in greater-than and less-than symbols

 

The following table describes the commands used for performing common actions related to network-user:

 

Action Description Command

Parameter Description
To manually configure a network object for a user [no] network-user static-user <user-name> address <IP-address> [group]
  • static-user <user-name> - The name of the user.
  • address <IP-address> - The corresponding static IPv4 or IPv6 address of the user. Multiple addresses may be specified.
  • group - The group that the user belongs to (optional)
To create a dynamic Network Object based on a user or group [no] network-user network-object <network-object> {group | user} <user or group>
  • network-object <network-object> - The name of the dynamic network object that will be created.
  • group <ad-group> - The Active Directory group name that the dynamic network object will be mapped to.
  • user <ad-user> - The Active Directory user name that the dynamic network object will be mapped to.


Example

Create a dynamic Network Object called 'Students Network Object' from the Active Directory 'Students' group:

network-user network-object "Students Network Object" group Students

 

Find more CLI commands.

Back to Top