Phone Lines icon GFI Support

Articles in this section

See more

Exinda CLI: Web UI and Web Proxy

Author: Sughra Mehdi Updated

Overview

 

This article provides information regarding the Exinda CLI command web.

You can use the web command to configure the web user interface (Web UI).

 

Information

 

NOTE:  The following syntax convention is used:
  • {}: Options are enclosed in braces and are separated by '|'
  • []: Optional keywords are enclosed in brackets
  • <>: User input is required where variables are enclosed in greater-than and less-than symbols

The following table describes the commands used for performing common actions related to web:

Action Description Command

Parameter Description

To enable or disable the Web UI

 [no] web enable Not Applicable 

To configure the length of user inactivity before auto-logout (in seconds)

 web auto-logout <time> Not Applicable 
To configure HTTP access to the Web UI web http {enable|port|redirect|restrict}
  • enable - Enable HTTP access to web UI.
  • port <port-number> - Set the port number for HTTP access to the web UI.
  • redirect - Enable redirection to https.
  • restrict <network-object> - Restrict access to the web UI for a particular named network object.
To configure HTTPS access to the Web UI https {enable|certificate|customssl|port|restrict}
  • enable - Enable https access to the web UI.
  • port <port-number> - Set the port number for https access to the web UI.
  • certificate regenerate - Configure a certificate for use for https connections.
  • customssl - Configure a custom SSL certificate.
  • restrict <network-object> - Restrict access to the web UI for a particular named network object.
To configure a custom SSL certificate https customssl {enable|certificate|generate csr country <country> state <state> location <location> organization <org> hostname <hostname>|privatekey}
  • certificate <certificate> – Specify the certificate to use.
  • country <country> – Type your country code. E.g. US.
  • state <state> – Type your state. E.g. California.
  • location <location> – Type your location. E.g. "San Franscisco".
  • organization <org> – Type your organization. E.g. "Exinda Networks".
  • hostname <hostname> – Type your full hostname to access your appliance.
  • privatekey <pkey> – Type a custom SSL private key that you have obtained or generated.

To configure renewal and timeout session settings

web session {renewal <number-of-minutes>|timeout <number-of-minutes>}

 Not Applicable 

To enable or disable deflate compression encoding

 [no] web httpd compression Not Applicable 

To enable or disable Web interface restrictions

 [no] web httpd listen {enable|interface <interface>} Not Applicable 

To restrict the listen interface for the Web UI. The configured interface should be statically configured (DHCP disabled)

 web httpd listen interface <interface> Not Applicable 

Configure the web proxy host address and port

 web proxy host <hostname or IP address> [port <port>]

host <hostname or IP address> - IPv4 and IPv6 addresses can be used.

To configure the type of proxy authentication

 web proxy auth authtype {none|basic} Not Applicable 

Configure the username and password for basic authentication

 web proxy auth basic {password|username} Not Applicable 

To show Web UI configuration and running state

 show web Not Applicable 

 

Find more CLI commands.

Back to Top