Overview

To use PBR, you should configure the interfaces on the Exinda appliance with the appropriate settings, using either the Exinda web UI or the CLI.

This article provides step-by-step instructions on how to configure an Exinda appliance for PBR using the CLI.

CAUTION! Configure your appliance using the IP addresses that correspond to your network. The IP addresses and netmasks used in this guide are for demonstration purposes only.

Process

On your browser, open the Exinda web UI (https://<Exinda_IP_address>).
Type the username and password.
Click Login.
Click Configuration > System > Tools > Console.
Type the appliance username and password at the prompts. Do one of the following:

To enter the privileged EXEC (enable) mode, run the command:
```
hostname > enable
```

The hostname # prompt appears.

To enter the configuration (config) mode, run the command:
```
hostname # configure terminal
```

The hostname (config)# prompt appears.

Remove the BR10 bridge:

hostname (config)# no bridge BR10 enable

Set the IP address and the netmask of the out-of-path Exinda appliance:
```
hostname (config)# interface eth11 ip address 10.10.10.2 /8
```
Identify the interface to be used for policy-based routing:
```
hostname (config)# pbr interface eth11
```

Set the IP address of the router:

hostname (config)# pbr interface ip next-hop 10.10.10.1

To set the parameters of eth11, type the following commands:

hostname (config)# no interface eth11 dhcp

hostname (config)# interface eth11 display

hostname (config)# interface eth11 duplex auto

hostname (config)# interface eth11 mtu 1500

hostname (config)# no interface eth11 shutdown

hostname (config)# interface eth11 speed auto

Configuring a Router for a Basic Policy-Based Routing Topology

Articles in this section

Configuring an Exinda Appliance for Policy-Based Routing Using CLI

Overview

Process

Related Article