The Email2FaxGateway settings specify how GFI FaxMaker communicates with the mail server for sending and receiving faxes.
From the Configuration Wizard or Email2FaxGateway dialog, click Test to ensure correct communication between the two servers.
This article provides some of the common failure error messages and possible solutions.
|The transport failed to connect to the server.||
Connection with the mail server couldn’t be established. Confirm the following settings:
|The server rejected one or more recipient addresses. The server response was: 550 5.7.1 Unable to relay for <email address>.'||
Connection with the mail server was established but the mail server refused the domain of the recipient's address.
This normally occurs because relaying is not allowed from the GFI FaxMaker server. Configure the SMTP server to accept relaying from the GFI FaxMaker machine's IP or allow relaying for the internal email domain only.
|The server rejected the sender address. The server response was: 530 5.7.1 Client was not authenticated.||If the GFI FaxMaker server has more than one network interface card (NIC), you may need to configure the NIC properties to force traffic to the mail server to use the correct interface.|
|The server rejected the sender address. The server response was: 530 5.7.3 Client was not authenticated.||
Your mail server requires authentication and you have not entered the authentication details. Go back to the SMTP server configuration and configure the authentication details.
You can also configure the SMTP server to accept anonymous SMTP connections (if it is only available to the intranet).
|The message could not be sent to the SMTP server. The transport error code was 0x80040217. The server response was not available.||GFI FaxMaker can connect with mail server but user authentication details are invalid. Check the credentials.|