SummaryDynamic Virtual Circuits can be configured to limit per user bandwidth, but sometimes it will not work.
OverviewWhen setting up a Dynamic Virtual Circuit, there is an option to set per user bandwidth. If the configuration appears to be correct, but the traffic for the users is not being limited as specified, please check the following:
- Make sure the traffic is appearing in the correct virtual circuit in Monitor > Real Time (select Show Policies to check)
- Confirm that the 'Per Host Max Bandwidth' section has the 'No Bursting Allowed' checkbox checked, or that the max bandwidth is set as desired amount
If everything appears to be correct after double-checking the above options, then this could be caused by a software defect.