Overview

You can configure the path to the datastore during the installation of Kerio Connect.

Refer to the following articles to understand the installation process based on your operating system:

• Installing Kerio Connect on Linux RPM
  
  
• Installing Kerio Connect on Linux Debian/Ubuntu
  
  
• Installing Kerio Connect on macOS X
  
  
• Installing Kerio Connect on Windows
  
  

This article defines the process to change a predefined datastore location in Kerio Connect after the installation.

Process

1. Create a new folder for the datastore. Do not use diacritics and make sure there is enough free space for the data store.
   
   NOTE: The folder must be on a local disk. If you are using a virtual machine, define the disk as local.
2. In the Kerio Connect administration interface, go to Configuration > Advanced Options > Store Directory.

1. Select the new folder from the new location. Do not use a UNC path.
2. Click OK and then Apply.

1. Stop Kerio Connect.
2. Copy all the files from the old store directory to the new directory.
3. Run Kerio Connect.
   
   

Confirmation

Kerio Connect datastore is now set to the new path that you defined, and all the datastore files reside in it.